Epson Stylus Color C70 Service Manual page 174

EPSON Stylus COLOR C70/C80
8. Get 2 new oil pads, and 2 new "sub oil pads".
9. To one of the new oil pads, supply ""O-12"" (0.5 cc) using the small syringe.
Supply "O-12" (0.5 CC)
Figure 6-5. Supplying Oil to the Oil Pad (1)
10. Using the oiled side of the pad (step 8), lubricate the carriage guide shaft surface
thoroughly.
Oil Pad already oiled with "O-12" (0.5 CC)
Figure 6-6. Preliminary Lubrication with "O-12"
11. Install the other new oil pad to the specified position at the back of the carriage.
12. Install new sub oil pads to both bushing of the carriage, and re-attach 2 springs to
secure 2 sub oil pads.
Maintenance
to the oil pad.
Overview
13. Using the same syringe used in Step 9, supply "O-12" (0.49 - 0.53 cc) to the
installed oil pad.
"O-12"
0.13 - 0.16 cc
Figure 6-7. Supplying Oil to the Oil Pad (2)
14. Using the same syringe used in step 9, supply "O-12" (0.13 cc to 0.16 cc) to both
new sub oil pads.
15. Install the carriage guide shaft to the carriage unit then to the printer main body.
(See Chapter 4 / Section 4.2.6)
16. Install the printhead. (See Chapter 4 / Section 4.2.5)
17. Perform Paper Gap Adjustment. (See Chapter 5 / Section 5.2.9)
18. Turn the printer on without the ink cartridges installed to cause the Ink Cartridge
Out Error.
19. Using the Load/Eject button, run the Ink Cartridge Replacement Sequence and
install new ink cartridges.
20. Using the service program, perform Initial Ink Charge. (See Chapter 5 / Section
5.2.3)
21. Perform Head Angular Adjustment. (See Chapter 5 / Section 5.2.4)
22. Perform Bi-Directional Adjustment. (See Chapter 5 / Section 5.2.5)
23. Perform PF Adjustment. (See Chapter 5 / Section 5.2.6)
Revision A
"O-12"
0.49 - 0.53 cc
"O-12"
0.13 - 0.16 cc
174