Threading Of Lower Tape Feed (Only 550-12-16) - Duerkopp Adler 550-12-23 Operating Instructions Manual

4.9 Threading lower tape feed (550-12-26 only)
3
Caution Risk of Injury !
Before threading turn the main switch off.
Threading the tape
–
Put the roll in place.
–
Pass tape over clamping lever.
–
Place top in position.
–
Thread tape as shown in illustration.
–
Press key 3 once to release the tape clamp.
–
Thread tape into channel 1 as far as the tape cutter 2.
–
Press key 3 again to close the tape clamp and activate the
tape cutter.
–
Begin sewing.
Removing residual tape from tape channel in needle plate
–
Press key 3 once.
–
Push pedal forwards.
–
Remove residual tape with tweezers.
–
Press key 3 again.
Note:
When sewing with a programme, it will be impossible to activate the
key 3 for inserting the tape and for removing the tape remnant before
the pedal has been lowered backwards.
2
1
25