Printing The Nozzlejob Test Print - Gerber SOLARA UV2 Owner's Manual

CHAPTER 6
Routine Printer Maintenance

Printing the NozzleJob test print

Print the NozzleJob test print located in the Test Jobs menu to verify that all the nozzles on the
print head are working properly. The test job exercises each of the print head nozzles from left
to right. The nozzles used to print the horizontal lines in the test are listed above each section.
The vertical lines between each section do not have to line up for the test to work properly.
There are 14 sections total, each with 9 horizontal lines per color.
To print the NozzleJob test print
1 Load Gerber-qualified white material in the printer.
2 Press F3, Setup from the MAIN MENU to open the SETUP MENU.
F2
3 Press F2, Diag to open the DIAGNOSTICS menu.
F1
4 Press F1, Test Jobs to open the TEST JOBS menu.
F1
5 Press F1, NozzleJob to run the test job. The Job Status will change from
(just like a normal print job).
Start-Job
F1
6 Verify that the correct material is loaded in the printer and press F1, Start-Job.
SETUP MENU
Network
Diag
ENTER for Main Menu
DIAGNOSTICS
Test Jobs
Versions
TEST JOBS
NozzleJob
BiDirCal
ENTER for Main Menu
MAIN MENU
Start-Job
Mode: Single
Job Status: Ready
Calibrate
Vacuum
Language
Err History
EncoderJob
More...
Setup
Operate
101
to
Ready