Uv Lamp Assembly Maintenance - Gerber SOLARA UV2 Owner's Manual

CHAPTER 6
Routine Printer Maintenance
ERROR # MESSAGE
29 Keypad: 'Receive' error in communications
30 Keypad: Error while erasing
31 Keypad: No Response during erasing
32 Keypad: Programming error
33 Keypad: No Response during programming
34 Keypad: System held in RESET
35 Keypad: No Response during RESETTING
36 Keypad: Unknown state of operating system
37 Carriage: Invalid File Format
38 Carriage: No device found
39 Carriage: System reporting an error
40 Carriage: FPGA reporting an error
41 Carriage: No in a ready state
42 Carriage: Illegal state of operating system
43 Carriage: Unknown File Format

UV lamp assembly maintenance

Depending on number of strikes and operating conditions, the UV bulb life is typically 500
hours of use (1700 hours of lamp life). After extended use the UV bulbs deteriorate, curing
effectiveness is reduced, and the UV lamp cartridge must be replaced. Inadequate curing may
not be visible but can lead to printed image failure at any time in the future. Gerber is not
responsible for printed image failures that result from the failure to comply with recommended
lamp replacement.
If a lamp fails it will appear cloudy in the center of the bulb as shown in the following photo.
ACTION
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Make sure the correct file was
chosen for downloading. Retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Cycle power to printer and retry.
Make sure the correct file was
chosen for downloading. Retry.
Failed lamp has a cloudy
appearance in the center
of the bulb.
123