Manually Starting An Ink Refill; Checking Ink Levels - Gerber SOLARA UV2 Owner's Manual

CHAPTER 4
Loading Inks and Materials

Manually starting an ink refill

You must start an ink refill to replenish the reservoir after installing a new ink cartridge. You
can start an ink fill while printing. The Start Refill command is located in the INK MENU.
1 From the MAIN MENU press F4, Operate to open the OPERATION menu.
F2
2 Press F2, Ink to open the INK MENU.
Levels
F2 Start Refill
ENTER for Main Menu
3 Press F2, Start Refill to begin the refill cycle. The display briefly shows the message
above, and then returns to the previous menu.

Checking ink levels

When preparing to print you can see the amount of ink in the reservoirs and if an ink cartridge
is empty by using the INK LEVEL DISPLAY menu.
1 From the MAIN MENU press F4, Operate to open the OPERATION menu.
F2
2 Press F2, Ink to open the INK MENU.
F1
3 Press F1, Levels to open the INK LEVEL DISPLAY menu. The ink levels display
according to the key. In the following illustration, the Violet cartridge is empty and the
Magenta ink reservoir and cartridge are empty.
INK LEVEL DISPLAY
COLOR: K
LEVEL: F
(Press a key)
4 Press any key to return to the MAIN MENU.
OPERATION
Material
Ink
ENTER for Main Menu
INK MENU
Service
Prime
OPERATION
Material
Ink
ENTER for Main Menu
INK MENU
Levels
Start Refill
ENTER for Main Menu
V C M G Y
e F E F F
Lamps
Job
INK Refilling
Has started!
Lamps
Job
Service
Prime
F Full
e Ink Cartridge empty
E
Ink Reserve and Cartridge empty
?
Fault (Service Required)
41