Manually Initiating A Material Width Scan - Gerber SOLARA UV2 Owner's Manual

CHAPTER 4
Loading Inks and Materials

Manually initiating a material width scan

There are several reasons why you may need to manually initiate a material width scan:
♦ The UV shields are not positioned correctly or you have a material scan error message:
♦ If the material is loaded too far beyond ¼" (6mm) to the right of the right-most pinch
wheel and you have received the following message:
To manually initiate a material width scan
1 Load material in the printer. See "Loading the material" on page 42.
2 From the MAIN MENU press F4, Operate to open the OPERATION menu.
F1
3 Press F1, Material to open the MATERIAL menu.
F2
4 Press F2, Reload to open the Select Material Type menu.
F2
5 Press F2 if vinyl material is loaded, or press F4 if rigid material is loaded. The GERBER
SOLARA UV2 will automatically home and scan the material.
Note: If the GERBER SOLARA UV2 fails to detect the material width after a scan, see the
troubleshooting chart at the end of this section.
ERROR: MATERIAL SCAN
RT Shield Gap Large
Move Shield Closer
(Press any key)
ERROR: Material too
far to the right.
Reposition material
then do MATL SCAN.
OPERATION
Material
Ink
ENTER for Main Menu
MATERIAL
Width Info.
Reload
ENTER for Main Menu
Select Material Type
Rigid Bleed-
-Vinyl
(CANCEL to Abort)
Lamps
Job
Set Width
Rigid- F4
69