Removing Material From The Winding Unit - Gerber SOLARA UV2 Owner's Manual

CHAPTER 4
Loading Inks and Materials

Removing material from the winding unit

The winding unit is equipped with a free-wheeling mode that allows easy removal of wound
material from the take-up roll.
To remove the material from the winder
1 Carefully cut the printed material off of the supply roll.
2 Lift the left end of the material take-up roll and slide it to the right so that the take-up
roller hub rests on the idler roller. This allows the take-up roll to move freely.
3 Unwind the material from the take-up roll.
4 After removing the material, return the take-up roll to the drive roller position.
Take-up roll hub
Idler roller
Take-up roller
hub in drive
position
59