The Solara Uv2 Web Pages; Accessing The Solara Uv2 Web Pages - Gerber SOLARA UV2 Owner's Manual

CHAPTER 6
Routine Printer Maintenance

The SOLARA UV2 web pages

The GERBER SOLARA UV2 has an onboard interface program that can be accessed directly
from any user computer via an internet browser (such as Internet Explorer or Netscape). This
program can be used to check on the printer's current status, install new UV lamps and to install
new firmware. To access the web pages you will need the following:
♦ A user computer with an internet browser either directly connected to the machine or
connected to a network which is connected to the machine. (See section "Networking the
SOLARA UV2" for more information). The computer does not have to be connected to
the internet to access the printer web pages.
♦ The printer's IP address.
See "Viewing the current network settings" on page 32.

Accessing the SOLARA UV2 web pages

Once you have a computer with an internet browser (no internet connection required) and that
computer is connected to the printer either directly or via a network, you can access the
GERBER SOLARA UV2 web pages.
To access the GERBER SOLARA UV2 web pages
1 Open a web browser menu on the connected computer. (The internet connection does
not have to be active.)
2 Enter the IP Address for the specific GERBER SOLARA UV2 you wish to access as the
web address in the web browser. (Do not use any slashes or colons.)
3 If done correctly the Home page should appear on your web browser. There is a list of
links on the right side of the screen to the other pages in the program as listed on the
following pages.
Insert the IP Address
and hit the Enter key
105