Activating Your Gerber Solara Uv2 Printer - Gerber SOLARA UV2 Owner's Manual

CHAPTER 3
Setting up the GERBER SOLARA UV2

Activating your GERBER SOLARA UV2 printer

This page is for activating or adding hours of print time to GERBER SOLARA UV2 printers that
are being financed, leased or under other restrictions. For most owners no activation should be
necessary and the printer should be set to unlimited hours of operation.
Tip: You can check the current activation status using the GERBER SOLARA UV2 control
panel or web pages, but you can only change the activation settings using the web pages.
(For more information see "The SOLARA UV2 web pages" on page 105.)
To check the activation status (via the control panel)
1 From the MAIN MENU press F4, Operate to open the OPERATION menu.
2 Press F4, Job to display the JOB OPERATION menu.
F3
3 Press F3, Activation to display the current activation status.
Displays current activation status
and available print-hours left
4 Press any key to return to the MAIN MENU.
To check the activation status (via the web pages)
1 Verify that there is a computer with an internet browser either directly connected to
the printer or connected to a network which is connected to the printer. (See section
"Networking the SOLARA UV2" for more information). The computer does not have
to be connected to the internet to access the printer web pages.
2 Open a web browser menu on a computer connected to the printer.
(The internet connection does not have to be active.)
3 Enter the IP Address for the specific GERBER SOLARA UV2 you wish to access as the
web address in the web browser and press enter. (Do not use any slashes or colons.)
OPERATION
Material
Ink
ENTER for Main Menu
JOB OPERATION
Justify
Activation
ENTER for Main Menu
JOB ACTIVATION TIME
Hrs Left:
Press F3 or ENTER
Lamps
Job F4
Job Info
Displays brief instructions for
Details-
activating printer via the web pages
INFINITE
34