Wagon Wheel Test Plot - Gerber HS750 Plus User Manual

plus
48 HS750
Square/Circle Test Plot
!
check X, Y, Z, and theta axes in cut mode and to verify
operation after adjustments are made.
X08 Cut Test
!
test cut quality.
Note: If the plotter consistently fails a special diagnostic, contact
Gerber Field Service Department at 800-828-5406, or fax at 203-
645-2448.

WAGON WHEEL TEST PLOT

To plot the Wagon Wheel Test Plot
1. Load plotting paper and install the pen holder.
2. Press left arrow key to access diagnostic.
3. Press
continuously.
4. Compare the test plot to the illustration below. If they do not
look the same, call Gerber Field Service.
Press the down arrow key to access. Used to
to plot once or
RUN SINGLE
Press the key. Used to
SLOW
to plot
RUN CONT