Exploring The Main Menu; F1, Start-Job, Pause-Job, Or Blank; F2, Mode; F3, Setup - Gerber SOLARA UV2 Owner's Manual

CHAPTER 2
Product Overview

Exploring the MAIN MENU

The MAIN MENU of the control panel displays after the start-up sequence when the printer is
idle. From the MAIN MENU you can access the menus and commands used to operate the
GERBER SOLARA UV2.
F1
F2

F1, Start-Job, Pause-Job, or blank

The F1 line of the MAIN MENU changes depending on the state of the GERBER SOLARA UV2.
It is blank when the printer is idle in Single mode, it displays
, or changes to
Ready Pause-Job
Job Status F1 Message
No Job
Blank
Ready
Start-Job
Paused
Start-Job
Running
Pause-Job

F2, Mode

The F2, Mode command of the MAIN MENU sets the printing state to
"Choosing a print mode" on page 75 for details.

F3, Setup

The F3, Setup command of the MAIN MENU opens the SETUP MENU where you can access
the following printer controls:
F1
F2
♦ F1, Network to view the current network addresses or configure different addresses of
the printer.
♦ F2, Diagnostics to view the current firmware versions, set language, and adjust
calibration values.
♦ F3, Calibrate to adjust calibration values. (Calibration printing is initiated by external
jobs or by Test Jobs in the Diagnostic menu.)
♦ F4, Vacuum to manually enable or disable the vacuum fans. The vacuum is on by
default, but can be disabled for light-weight materials.
MAIN MENU
Mode: Single
Job Status: No Job
when the Job Status is
Function
None
Begin job
Resume job
Stops printing
SETUP MENU
Network
Diag
ENTER for Main Menu
Setup F3
Operate F4
when the Job Status is
Start-Job
and printing is suspended.
Running
Single
Calibrate F3
Vacuum F4
20
or . See
Multi