Using The Winding Unit - Gerber SOLARA UV2 Owner's Manual

Ink jet printer

Table of Contents

CHAPTER 4

Loading Inks and Materials

16 After the beam height has been adjusted correctly, the GERBER SOLARA UV2

displays the following message if the front cover or the shutter door is open:

17 Once the front cover and the shutter door are closed, the GERBER SOLARA UV2

displays the following message:

18 Press F2 to select VINYL material type.

19 The GERBER SOLARA UV2 will automatically home the carriage and scan the

material to determine its width.

Note: Once the beam height is set for a given material, readjustment should not be required if

the material is moved, realigned, or reloaded.

Using the winding unit

The GERBER SOLARA UV2 is equipped with a roll feed/take-up roll system to maintain

proper positioning of the material during printing. Due to the UV-curable technology there are

no pre- or post-heaters required to dry inks. Printed material may be immediately wound onto

a take-up roll making unattended operation possible.

The winding unit requires standard 110V power.

Direction and

Rotation switches

Winding unit

MATERIAL SETUP:

Close Front Cover

And Shutter or Press

CANCEL for Main Menu

Select material type

Rigid Bleed-

-Vinyl

(CANCEL to Abort)

Take-up roller hub

Material sensor

Rigid-

GERBER SOLARA

UV2 stand

Take-up roller

Table of Contents