Viewing Scanned Material Width - Gerber SOLARA UV2 Owner's Manual

CHAPTER 4
Loading Inks and Materials
Note: If the GERBER SOLARA UV2 fails to scan rigid material after indexing the material to
the front sensor, the printer will NOT index the material back to the starting point. The user
must manually slew the material back to the intended starting point using the slew keys on the
control panel and then repeat the scan process.

Viewing scanned material width

After the GERBER SOLARA UV2 has scanned material it will record the material width and
calculate the maximum possible job width. You can view this information by accessing the
Material Menu from the control panel.
To view scanned material width
1 From the MAIN MENU press F4, Operate to open the OPERATION menu.
F1
2 Press F1, Material to open the MATERIAL menu.
F1
3 Press F1, Width Info to open the MATERIAL WIDTH menu. The material width and
the maximum job width in the nearest inch and cm are displayed.
4 Press ENTER to return to the MAIN MENU.
Note: The printer will automatically apply the printing margins based on the material type
selected when loading material and give two values, one for the actual material width and
another for the maximum printable job width.
OPERATION
Material
Ink
ENTER for Main Menu
MATERIAL
Width Info.
Reload
ENTER for Main Menu
MATERIAL WIDTH:
48.52 in 123.2 cm
MAX JOB WIDTH
48.02 in 122.0 cm
Lamps
Job
Set Width
70