Messages - Gerber SOLARA UV2 Owner's Manual

CHAPTER 7
Troubleshooting

Messages

The following messages may appear on the GERBER SOLARA UV2 display. The first group of
messages appear on the Job Status line of the display. The second group of messages are
common warning messages. The third group lists the common numbered error messages.
Job Status Messages
MATERIAL WIDTH SCAN
**** HOMING ****
LAMP WARM-UP
LAMP COOL-DOWN
** LAMP TEMP FAULT**
**LAMP COVER FAULT**
** LAMP LIFE LOW **
*LAMP LIFE EXPIRED!*
INK CARTRIDGE EMPTY!
*INK RESERVE EMPTY*
**INK SENSOR FAULT**
** PREHEATING **
Common Warning Messages
PRINTER WARMING UP!
** Printing Pending **
JOB CANCELED !
*** COVER OPEN ***
Close the Main Cover
and Head Shutter.
Press any key.
** JOB CANCELED **
Printer Cover or
Head Shutter Opened.
(Press ENTER)
Description
Material width scan is in progress.
Carriage homing operation is in progress.
Lamps are turned on and warming up.
Lamps are turned off and cooling down.
Lamp over-temperature fault detected.
Sensors indicate that the lamp bulb module is not properly
connected with the lamp housing.
One or both lamps are approaching the end of expected lifetime.
One or both lamps have reached the end of expected lamp
lifetime and should be replaced.
One or more ink cartridges are empty. Jobs may continue to be
run, but will be suspended if the ink reservoir becomes empty
during the job.
An ink reservoir is empty. Jobs may not proceed until the ink
cartridge is replaced and the ink level rises above the low level in
the reservoir. A suspended job may continue after refilling
without ruining the job.
Sensors are indicating simultaneous full and empty levels.
Indicates sensor or wiring fault.
Normal warm-up at job start.
Description
Print head temperature not at 40º C. Job will automatically start
when print heads reach proper temperature.
Job canceled by user. This message appears briefly.
Either the main printer cover or the head shutter door sensors
indicate that they are open. Close the open cover or door.
Job has been automatically cancelled because the printer cover or
head shutter door was opened.
146