Installing/Replacing The Battery - Cardinal Detecto MB150 User Manual

INSTALLING/REPLACING THE BATTERIES
The scale use six "AA" alkaline batteries (not included). You must first obtain and install
batteries before operations can begin. Batteries are contained in a battery holder inside the
scale. Access is via a removable panel on the bottom of the scale.
1. Turn the scale over so that the display is
facing down.
2. Locate the rectangular panel on the bottom of
the scale.
3. To install or replace the batteries, first remove
the battery holder cover by pushing in on the
tab and lifting it up.
4. If installing new batteries, proceed to step 5.
If replacing the batteries, remove all 6 batteries
from the battery holder and then proceed to
step 5.
5. Install the 6 new "AA" batteries in the battery holder, noting the polarity markings located in
the battery holder.
6. After placing all 6 batteries in the holder,
replace the battery cover.
7. Turn the scale over (display facing up) and
press the On/Off key.
8. If the scale turns on, the batteries have been
installed correctly. If not, remove the panel
and check for one or more improperly
positioned batteries.
9. The scale is now ready for normal weighing
operations.
8535-M212-O1 Rev A • MB150
3