Weighing Unit Switch; Rs232 Output Port; Low Battery; Error And Status Messages - Cardinal Detecto SlimPRO Operation Manual

Weighing Unit Switch

The weighting unit switch (kg /lb switch) is a push-button switch located on the bottom of the
scale. Press the switch to toggle between kg and lb. Note that the default setting unit is kg.
1. With the scale off, press the push-button.
2. Zero weight and the current weighing unit setting will be shown on the LCD, e.g. 0.0 kg.
3. Press the push-button again to toggle to lb.
4. Zero weight and the new weighing unit setting will be shown on the LCD, e.g. 0.0 lb

RS232 Output Port

1. RS232 output is always is on after power up.
2. The default setting of the baud rate is 9600, 8, N, 1.
3. Once the weight is locked, the weight value is transmitted out the RS232 port.
4. Requires an optionally purchased interface cable to communicate to a printer or computer.
NOTE: Zero weight or Error messages are not transmitted out port RS232 port.

Low Battery

When the battery voltage has dropped too low for accurate weighing, the
be displayed for 2 seconds and the scale will automatically turn off. Remove the old batteries
and replace with new batteries before continuing operation.

Error and Status Messages

NOTE: The error messages are shown for about 2 seconds and then the scale will turn off.
Display
Err0
Err1
Err2
Batt
Weight 82.4KG
Fig. 3: RS232 Output Format
Incorrect initialization – The scale must be reset..
Unstable weight.
Overload – Scale weight exceeds scale capacity.
Battery Low
8525-M336-O1 Rev A  SlimPRO Operation
Meaning
bAtt
message will
3