Canon LASER CLASS 1060P User Manual page 173

No automatic switching between telephone and fax calls.
The unit may not be set to switch automatically between telephone and fax calls.
• For the unit to switch automatically, the receive mode must be set to Fax/Tel Mode,
ANS.MACHINE MODE, or DRPD (1 Chapter 8). If you have set ANS.MACHINE
MODE, confirm that an answering machine is connected to the unit and that it is
turned on with an outgoing message properly recorded (1 p. 8-9).
The unit may have a document stored in memory, leaving little or no memory
available.
• Print, send, or delete any documents you no longer need to be stored in memory
(1 p. 9-4).
An error may have occurred during reception.
• Check the LCD for an error message (1 p. 13-8).
• Print an ACTIVITY REPORT (1 p. 11-3) and check for an error code (1 p. 13-8).
The multi-purpose tray may be empty.
• Make sure paper is loaded in the multi-purpose tray (1 p. 2-15).
The other party's fax machine may not send the CNG signal that tells your unit
that the incoming call is a fax call.
• Some fax machines cannot send this signal. In such cases, you will have to receive
the fax manually (1 p. 8-6).
Cannot receive a document manually.
You may have disconnected the call by pressing Start/Copy or dialing the remote
receiving ID after hanging up.
• Always press Start/Copy or dial the remote receiving ID before hanging up.
Otherwise you will disconnect the call (1 p. 8-6).
Print quality is poor.
You may not be using the correct paper type.
• Make sure you load paper that meets the requirements for the unit (1 p. 5-2).
The other party's fax machine may not be functioning properly.
• The sending fax machine usually determines the unit's quality. Contact the other party
and have them check that the scanning components of their fax machine are clean.
Error Correction Mode (ECM) may be disabled.
• Make sure ECM is on (1 ECM RX, p. 14-7).
Faxes do not print.
The toner cartridge may not be installed properly.
• Make sure the toner cartridge is installed properly (1 p. 2-12).
The toner cartridge may need to be replaced.
• Replace the toner cartridge (1 p. 12-6).
Chapter 13
13-17
Troubleshooting