Canon LASER CLASS 1060P User Manual page 101

n
• You can enter the fax numbers
in any order.
• If you enter a wrong destination,
press Clear, then enter the
correct destination.
• You must enter the second
destination within five seconds of
entering the first one. All
subsequent destinations must be
entered within 10 seconds. If you
wait longer than these times,
your unit automatically begins
scanning the document for
sending. If you do not want your
unit to begin scanning
automatically after a few
seconds, disable the TIME OUT
setting (1 p. 14-6).
• To review the destinations
entered, use ∂ or ¨ to scroll
through the numbers.
3
Press Start/Copy to begin scanning
for sending, or wait a few seconds for
your unit to begin scanning
automatically.
• Your unit will first send the document to
the one-touch speed dialing
destinations, then the coded speed
dialing destinations, and finally to the
destination dialed using regular dialing.
• If you do not want your unit to begin
scanning automatically after a few
seconds, disable the TIME OUT setting
(1 p. 14-6).
• To cancel sending once dialing has
started, press Stop then T. Sending to
all destinations you specified in step 2
will be canceled. (You cannot cancel
only one destination.)
n
• If a number is busy, your unit will continue sending to the other destinations and then
automatically redial the number that was busy.
• If the unit's memory becomes full while scanning your document, MEMORY FULL will
appear in the LCD. If this happens, remove the remainder of the document from the ADF
(you may need to open the operation panel to do so), then divide the document into
several sections and send each section separately.
Chapter 7
7-13
Sending Faxes