AT&T OneVision DEFINITY G3 Fault Management User Manual page 84

How Fault Manager Displays Faults
Table 5-2. Field Descriptions for Alarms Reports
Field
# Alarms Found
Port
Maintenance Name
On Board?
Alt Name
Alarm Type
Description
The number of active alarms
The alphanumeric ID (location) of the alarmed
object.
Zeros in this field indicate the alarmed object
is not connected to a port (for example, a system
printer.)
Data for this report is sorted by port ID
number.
The logical name of the maintenance alarmed
object
The location of the detected fault.
y = The fault is on the associated circuit pack
n = The fault is not associated with this circuit
pack, but with on an off-board element that is
connected to the circuit pack
Another way to identify the maintenance
object.
If the object is a station, this field contains the
extension number.
If the object is a trunk, this field contains
xxx/yyy, where:
— xxx = the trunk group number
— yyy = the member number
If the object is a private CO line, this field
contains P/nnn, where:
— P = private
— nnn = the line group number
The severity of the fault, as follows:
MAJOR
MlNOR
WARNING
5-5
Issue 2 April 1996