Output Options Messages - AT&T OneVision DEFINITY G3 Fault Management User Manual

Output Options
Table 8-3. Field Entry Area
Append
Delimiter
Page Length

Output Options Messages

The message area at the bottom of the screen displays the following types of
messages:
Message
Prompts
System
Message
8-6
Issue 2 April 1996
Allows you to append the report to an existing file. The
default is OFF.
Specifies the field delimiter for an ASCII file.
The default is | (pipe.)
This field is required if you selected ASCII as the
report format. If you selected Formatted, you cannot
access this field.
You can reset the default delimiter on the Setup
screen.
The number of lines in a page.
This field is required if you selected Formatted as the
report format. If you selected ASCII, you cannot
access this field.
Default = 66 lines
Minimum = 15 lines
Maximum = 999
Description
Messages that remind you to enter data into required fields.
These types of messages display after you select Ap ply.
Messages that inform you if Fault Management fails to
append or to write a file as requested. You can change your
field entries and try again.