AT&T OneVision DEFINITY G3 Fault Management User Manual page 117

Report Builder Screen
Table 7-3. Field Entry Area
To Value
Partial Match?
Table to Output
Sort Output First
By
Then By
Then By
Subsequent sections in this Chapter explain how to use these fields to create
reports.
One of the following:
If you set the Comparison field to Equal, then you
cannot enter data into this field.
If you set the Comparison field to Range, then Fault
Management retrieves all data that fall in the range
created by this entry and the entry in the Value field.
If you set the Comparison field to Range, and if you
leave the Value field blank, Fault Management
retrieves all data equal to or less than the value in this
field.
Allows Fault Management to retrieve values that only
partially match the contents of the Value and To Value
fields.
Hint: If you need an exact match, make sure this check
box is off.
The name of the table to use for output. This field
determines the table's format.
You can select one of the following values from the
pull-down list:
Alarms (default)
Circuit Packs
DS1 Circuit Packs
Errors
Set of three fields that allow you to enter a key for sorting
the report.
Use the pull-down lists to select up to three sorting
parameters. Then select either ascending or descending
sequence for each parameter.
7-7
Issue 2 April 1996