Administration Mode; Entering And Leaving Administration Mode - AT&T MERLIN 3070 Administration Manual

ADMINISTRATION MODE

Administration mode is an operating state of your control unit and of your ad-
ministrator/attendant console that is very different from their everyday state of opera-
tion. With the system in administration mode, you are able to set up or change system-
wide options or features. When you put the system into administration mode, the but-
tons on the administrator/attendant console take on entirely different functions from
those they perform when the console is in regular call-handling mode.

Entering and Leaving Administration Mode

You must enter administration mode whenever you use the administrator/attendant
console to administer your system. The boxed instructions below tell you how to enter
administration mode.
Entering Administration Mode
1. Set switch A on the Processor Module of the control unit to Administer
(down).
Insert the administration mode button labels (see the back of this manual)
2.
in the administrator/attendant console.
3 Slide the T/P (Test/Program) switch on the left side of the console to P.
Red and green lights start flashing next to the administration mode buttons
labled Adm Opt and Adm Tel.
When you finish administration procedures at the console, you must leave administra-
tion mode to resume normal operation. Do this when you complete your initial system
administration and whenever you complete any changes in the future. The boxed
instructions below tell you how to leave administration mode.
Leaving
Administration Mode
1. Slide the T/P switch to the center position.
2. Set switch A on the Processor Module of the control unit to Attendant (up).
3. Remove the administration mode button labels from the console andin-
sert the regular call-handling labels used by the attendant.
16