Table of Contents
Advertisement
Installation Tips
NOTE. There is no built-in driver Integrated SAS in the SUSE Linux Enterprise
Server 9 Service Pack 3. You need an external USB floppy drive for applying
driver during the OS installation.
Since SUSE Linux Enterprise Server 9 Service Pack 3 cannot recognize the
1.
integrated SAS, you need to make a driver diskette from the EasyBUILD
7.1 build 300 first before the installation.
Boot the system form SUSE Linux Enterprise Server 9 Service Pack3
2.
bootable CD.
When you see the boot menu on the screen, select Installation, press F6
3.
then press Enter to continue.
Follow the instruction to load the integrated SAS driver from the driver
4.
diskette.
Follow the instructions to change the installation and service pack CDs
5.
during the installation. And follow the normal installation procedure to
complete the installation.
SUSE Linux Enterprise Server 9 EM64T Service Pack 3 (with
Integrated SCSI Hardware RAID)
Below information describes how to manually install SUSE Linux Enterprise
Server 9 EM64T Service Pack 3 on Altos R910 with integrated SCSI hardware
RAID.
Drivers Required
For SUSE Linux Enterprise Server 9 EM64T Service Pack 3 Installation, the
following device drivers are required.
Device
Onboard ATI
Radeon 7000 VGA
Onboard Intel
E8501 Chipset
Integrated SCSI
hardware RAID
Onboard Broadcom
BCM5704 Gigabit
Ethernet
Onboard USB 2.0
Hot-swap
backplane
Software Required
The management utility for integrated SCSI hardware RAID can be found in the
55
Version
Directory on EasyBUILD
N/A
Built-in
N/A
Built-in
2.20.4.6
Built-in
3.37
Built-in
N/A
Built-in
N/A
Built-in
Altos R910 Installation Configuration Guide
Advertisement
Table of Contents
