Table of Contents
Advertisement
Onboard LSI 1030
SCSI controller
Onboard Broadcom
BCM5704 Gigabit
Ethernet
Onboard USB 2.0
Hot-swap
backplane
Patch Required
For OpenServer 6.0.0 installation, the following patches are needed.
Patch
OpenServer 6.0.0 March
2006 CD1 Recut
Maintenance Pack 2
Configuring integrated SAS hardware RAID
Please refer to the Appendix B. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE1. There is no built-in driver for integrated SAS hardware RAID in the
OpenServer 6.0.0. You need an external USB floppy drive for applying driver
during the OS installation.
NOTE2. You MUST use the OpenServer 6.0.0 March 2006 CD1 Recut to boot the
system and do the installation.
Since OpenServer 6 cannot recognize the integrated SAS hardware RAID,
1.
you need to make a driver diskette before the installation.
Boot the system from OpenServer 6.0.0 March 2006 CD1 Recut.
2.
Follow the instructions to do the installation. When you see the message
3.
for loading HBA drivers as follows, please select "yes" and insert the
driver disk into floppy to apply the driver.
Load more HBA drivers? yes
After you applied the driver for integrated SAS hardware RAID, continue
4.
to follow the instruction to do the installation.
At Configuring optional software page, select Deferred for Network card
5.
option to skip the network installation. Install the network adapter after
OS installation finished.
61
Or you can contact GCSD for the
driver.
8.0.2
Built-in
8.0.2b-7.5.22
Built-in
N/A
Built-in
N/A
Built-in
Where to download
http://www.sco.com/support/update/download/release
.php?rid=161
http://www.sco.com/support/update/download/release
.php?rid=133
Altos R910 Installation Configuration Guide
Advertisement
Table of Contents
