Table of Contents
Advertisement
Integrated SAS
Onboard LSI 1030
SCSI Controller
Onboard Broadcom
BCM5704 Gigabit
Ethernet
Onboard USB 2.0
SAS Hot-swap
backplane
Installation Tips
NOTE. There is no built-in driver for Integrated SAS in the Red Hat Enterprise
Linux 4.0 EM64T Update3. You need an external USB floppy drive for applying
driver during the OS installation.
Since Red Hat Enterprise Linux 4.0 EM64T Update3 cannot recognize the
1.
integrated SAS, you need to make a driver diskette from the EasyBUILD
7.1 build 300 first before the installation.
Type linux dd update when the prompt boot: appears at the start.
2.
Please select the sda as the Driver Disk Source.
3.
Follow the instruction to load the integrated SAS driver from the driver
4.
diskette.
After loading the driver for integrated SAS, please follow the normal
5.
procedure to finish the installation.
SUSE Linux Enterprise Server 10 Installation (with Integrated
SAS Hardware RAID)
Below information describes how to manually install SUSE Linux Enterprise
Server 10 on Altos R910 with integrated SAS hardware RAID.
Drivers Required
For SUSE Linux Enterprise Server 10 Installation, the following device drivers are
required. Those drivers can be found in EasyBUILD 7.1 build 600 (or later).
Device
Onboard ATI
Radeon 7000 VGA
Onboard Intel
E8501 Chipset
Integrated SAS
hardware RAID
Onboard LSI 1030
SCSI controller
Onboard Broadcom
45
3.02.77
\Disk\r910\onboard\SAS\RHEL4U3X64\
3.02.77
The driver is bundled in integrated
SAS driver
3.43-rh
Built-in
N/A
Built-in
N/A
Built-in
Version
Directory on EasyBUILD
N/A
Built-in
N/A
Built-in
00.00.03.07
\Disk\R910\RAID\Integrated_SAS\SLES
10\
Built-in
3.49
Built-in
Altos R910 Installation Configuration Guide
Advertisement
Table of Contents
