Table of Contents
Advertisement
Altos R910 Installation Configuration Guide
Broadcom Advanced Control Suite Utility Installation
The Broadcom Advanced Control Suite utility installation is the same as
integrated SCSI hardware RAID enabled. Please refer to the Windows Server
2003 Enterprise Edition (with Integrated SCSI Hardware RAID) Broadcom
Advanced Control Suite Utility Installation section.
Windows Server 2003 Enterprise Edition (with Integrated SAS)
Below information describes how to manually install Windows Server 2003
Enterprise Edition on Altos R910 with integrated SAS.
Drivers Required
For Windows Server 2003 Installation, the following device drivers are required.
Device
Onboard VGA
Onboard Intel
E8501 Chipset
Integrated SAS
Onboard LSI 1030
SCSI controller
Onboard Broadcom
BCM5704 Gigabit
Ethernet
Onboard USB 2.0
SAS Hot-swap
backplane
Software Required
The management utility for the NIC can be found in the EasyBUILD 7.1 build
300 (or later).
Software
Broadcom
Advanced Control
Suite
Installation Tips
NOTE. There is no built-in driver for integrated SAS in Windows Server 2003.
You need an USB floppy for applying driver during the OS installation.
As Windows Server 2003 can't recognize the integrated SAS, you need to
1.
make a driver diskette from the EasyBUILD 7.1 build 300 first before the
installation.
Press F6 at the start of installation to provide the driver disk for the
2.
integrated SAS.
24
Version
Directory on EasyBUILD
6.14.10.6553
\Disk\R910\onboard\VGA
5.2.3790.1380
Built-in
1.21.15.00
\Disk\r910\onboard\SAS\WS2K3
1.09.11.0
\Disk\R910\onboard\SCSI\LSI\ultra320.n
et
8.48.0.0
\Disk\R910\NIC\BCM\ws2003
5.2.3790.1380
Built-in
5.0.6055.2
\Disk\r910\onboard\hsbp\sas
Version
Directory on EasyBUILD
7.7.6
\app\r910\NIC\BACS\2KXPWS03
Advertisement
Table of Contents
