Table of Contents
Advertisement
Windows Server 2003 Enterprise Edition (with Integrated SAS
Hardware RAID)
Below information describes how to manually install Windows Server 2003
Enterprise Edition on Altos R910 with integrated SAS hardware RAID.
Drivers Required
For Windows Server 2003 Installation, the following device drivers are required.
Device
Onboard VGA
Onboard Intel
E8501 Chipset
Integrated SAS
hardware RAID
Onboard LSI 1030
SCSI controller
Onboard Broadcom
BCM5704 Gigabit
Ethernet
Onboard USB 2.0
SAS Hot-swap
backplane
Software Required
The management utility for integrated SAS hardware RAID and NIC can be
found in the EasyBUILD 7.1 build 300 (or later).
Software
Intel RAID Web
Console 2
Broadcom
Advanced Control
Suite
Configuring Integrated SAS Hardware RAID
Please refer to the Appendix B. for the Integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver for integrated SAS hardware RAID in the OS.
You need an USB floppy for applying driver during the OS installation.
As Windows Server 2003 can't recognize the integrated SAS hardware
1.
RAID, you need to make a driver diskette from the EasyBUILD 7.1 build
300 first before the installation.
Press F6 at the start of installation to provide the driver disk for the
2.
21
Version
Directory on EasyBUILD
6.14.10.6553
\Disk\R910\onboard\VGA
5.2.3790.1380
Built-in
1.17.0.32
\Disk\r910\raid\Integrated_SAS\ws2k3
1.09.11.0
\Disk\R910\onboard\SCSI\LSI\ultra320.n
et
8.48.0.0
\Disk\R910\NIC\BCM\ws2003
5.2.3790.1380
Built-in
5.0.6055.2
\Disk\r910\onboard\hsbp\sas
Version
Directory on EasyBUILD
1.13-07
\app\r910\Integrated_SAS\Windows\
7.7.6
\app\r910\NIC\BACS\2KXPWS03
Altos R910 Installation Configuration Guide
Advertisement
Table of Contents
