Adjustment Of Presser Foot Height - Brother BE-0901E-AC-PC Instruction Manual

3. Adjustment of Presser Foot Height

1. Turn the power switch off.
2. Select the needle bar No. 1.
3. Loosen the screw [2] of the presser foot [1], and adjust the presser foot [1] until it comes above the
cloth top surface when it is at the alignment position (where the pulley B indication mark " " and
the cover indication mark " " are aligned).
Note) When the presser feet have been adjusted in height, check that each needle lowers to the center of
the presser foot hole.
4. Turn on the power switch and lower presser foot [1] with the lever.
W1627
BE-0901E-AC-PC• BE-1201B-AC-PC
W1628
Chapter 10 Adjustment
[2]
[1]
material
W1629
10-7