DAELIM VJF125 Service Manual page 212

AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT
AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT
AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT
AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT AXLE SHAFT
SIDE COVER SIDE COVER SIDE COVER SIDE COVER SIDE COVER
SIDE COVER SIDE COVER SIDE COVER SIDE COVER
SIDE COVER SIDE COVER SIDE COVER SIDE COVER SIDE COVER SIDE COVER
SIDE COVER SIDE COVER SIDE COVER SIDE COVER SIDE COVER SIDE COVER
SIDE COVER
FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS
FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS
FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS
FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS FLANGE BOLTS
REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY
REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY
REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY
REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY REAR CUSHION ASSY
REAR WHEEL/REAR SUSPENSION
REAR CUSHION
REMOVAL
MUD GUARD
MUD GUARD MUD GUARD MUD GUARD MUD GUARD MUD GUARD MUD GUARD
MUD GUARD MUD GUARD MUD GUARD MUD GUARD MUD GUARD MUD GUARD
MUD GUARD MUD GUARD MUD GUARD MUD GUARD MUD GUARD MUD GUARD
MUD GUARD MUD GUARD MUD GUARD
•The damper unit is filled with high pressure nitrogen
•Heating a gas-filled damper can lead to an explosive
INSPECTION
Install the axle nut temporary.
By tightening the chain adjust nut, adjust the drive
chain slack. (⇨2-8)
Tighten the axle nut to the specified torque.
TORQUE : 8.8 kgf·m
Raise and support the motorcycle with main stand.
Remove the rear wheel mudguard.
Remove the rear cushion lower flange bolt.
Remove the LH. side cover.
Loosen the rear cushion upper flange bolt, and remove
the rear cushion.
gas. Do not disassemble gas damper unit.
release of pressure which can cause a serious injury.
Visually inspect the rear cushion for damage.
Check for the :
- Damper rod for bend or damage
- Damper unit for deformation or oil leaks
- Cushion rubber for wear or damage
Check all the other parts for wear or damage.
If necessary, replace the rear cushion as an assembly.
15-7