Air Cleaner; Spark Plug - DAELIM VJF125 Service Manual

SCREWS SCREWS SCREWS SCREWS SCREWS
SCREWS SCREWS SCREWS SCREWS SCREWS SCREWS
SCREWS SCREWS
SCREWS SCREWS SCREWS SCREWS SCREWS
CHECK GAP,
DEPOSITS
CHECK FOR
CRACKS

AIR CLEANER

AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER
AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER
AIR CLEANER AIR CLEANER
AIR CLEANER AIR CLEANER AIR CLEANER
HOUSING COVER HOUSING COVER HOUSING COVER HOUSING COVER HOUSING COVER
HOUSING COVER HOUSING COVER HOUSING COVER HOUSING COVER
HOUSING COVER HOUSING COVER
HOUSING COVER HOUSING COVER HOUSING COVER HOUSING COVER HOUSING COVER
AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER
AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER
AIR CLEANER AIR CLEANER
AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER
ELEMENT ELEMENT ELEMENT ELEMENT ELEMENT
ELEMENT ELEMENT
ELEMENT ELEMENT ELEMENT ELEMENT ELEMENT ELEMENT
ELEMENT ELEMENT ELEMENT ELEMENT ELEMENT
SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH
SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH
SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH
SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH SPARK PLUG WRENCH
0.8~0.9mm
CHECK WASHER
FOR DAMAGE
INSPECTIONS / ADJUSTMENTS
AIR CLEANER
• Remove the seat. (⇨13-2)
• Loosen the 4 screws, remove the air cleaner cover.
• Remove the air cleaner element.
• Also replace the filter any time it is excessively dirty or
damage.
• Install in the reverse order of removal.
•Do not reuse the filter element to clean by
compressed air.

SPARK PLUG

• Remove the spark plug cap.
• Check the plug for damage, contamination or deposits.
• If the spark plug is severely contaminated or damaged,
raplace with a new one. If the plug can be reused after
removing only the carbon, use plug cleaner and wire
brush to clean the plug.
• Always use a feeler gauge to check the gap.
GENUINE PLUG : CR9EH-9
SPARK PLUG GAP : 0.8~0.9mm
TORQUE : 1.1kgf·m
•Make sure there is no dirt or debris on the seat of the
spark plug hole before inserting the spark plug.
•To prevent damage to the cylinder head, handtighten
the spark plug before using a wrench to tighten to the
specified torque.
•Do not overtighten the spark plug.
• Assemble the spark plug.
2-5