Operation Inspection - DAELIM VJF125 Service Manual

ELECTRIC STARTER
MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH
MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH
MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH
MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH MAGNETIC SWITCH
19-6
INSTALLATION
Coat a new O-ring with oil and install it into the starter
motor groove.
Install the starter motor into the crankcase.
Install the ground cable and mounting bolts, and
tighten the bolts securely.
Install the clutch wire holder.
Install the starter motor cable, then tighten the terminal
nut securely.
Install the rubber cap securely.
STARTER MAGNETIC SWITCH
REMOVAL
Remove the seat. (⇨13-2)
Remove the RH. side cover. (13-2)
Disconnect the battery
magnetic switch terminal.
Disconnect the starter motor cable from the starter
magnetic switch terrminal.
Disconnect the Yellow/Red and Green/Yellow
connector from the wire harness.
Remove the starter magnetic switch from the bracket
of the frame.

OPERATION INSPECTION

Shift the transmission into neutral.
Turn the ignition switch to "ON", and push the starter
switch button.
The coil is normal if the starter magnetic switch clicks.
If you don't hear the switch "CLICK", inspect the
magnetic switch using the procedure below.
wire cable from the starter
⊕