DAELIM VJF125 Service Manual page 235

HYDRAULIC BRAKE
16-18
PISTON SEAL PISTON SEAL PISTON SEAL
PISTON SEAL PISTON SEAL PISTON SEAL PISTON SEAL
PISTON SEAL PISTON SEAL PISTON SEAL PISTON SEAL
PISTON SEAL PISTON SEAL PISTON SEAL PISTON SEAL PISTON SEAL
DUST SEAL DUST SEAL DUST SEAL
DUST SEAL DUST SEAL DUST SEAL DUST SEAL
DUST SEAL DUST SEAL DUST SEAL DUST SEAL
DUST SEAL DUST SEAL DUST SEAL DUST SEAL DUST SEAL
Avoid spilling fluid on painted, plastic, or rubber
parts.
Keep oil off the brake disk or pad, because the
contaminated brake disk or pads reduce the braking
performance if contaminated.
Replace the pad with a new one and clean the disk.
DISASSEMBLY
Remove the pad spring, slide pin, caliper bracket and
boot from the caliper body.
If there is any wear or damage in the boot, replace it
with a new one.
Install corrugated cardboard or soft wood sheet
between the pistons.
Apply small squirts of air pressure to the brake hose
assembly part to remove the pistons from the caliper.
Do not use high pressure air or bring the air gun too
close.
Do not touch the inside of caliper.
Remove the piston seal and dust seal.
Be careful not to damage the caliper inside.
Clean the caliper inside and piston with brake fluid.
INSPECTION
Check the caliper friction surface for damage or
scratches.
Measure the caliper I. D.
SERVICE LIMIT : 25.07mm