Water Pump - DAELIM VJF125 Service Manual

CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE
CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE
CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE
CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE CHECKING HOLE
INLET HOSE INLET HOSE INLET HOSE INLET HOSE INLET HOSE
INLET HOSE INLET HOSE INLET HOSE INLET HOSE
INLET HOSE INLET HOSE INLET HOSE INLET HOSE INLET HOSE INLET HOSE
INLET HOSE INLET HOSE INLET HOSE INLET HOSE INLET HOSE INLET HOSE INLET HOSE
WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER
WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER
WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER
WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER WATER PUMP COVER
Connect the overflow tube and tighten it securely
with the tube clamp.
Fill the radiator with coolant.
Connect the vent tube to the radiator filler.
After installation, check for coolant leaks.
• The coolant must be filled up to the inlet.
Put the transmission gear in neutral and start the
engine.
Idling the engine for a few minutes, deflate air in
cooling system with a snap slightly, then refill the
coolant.
After checking the amount of coolant in reserve
tank, if it is not enough, fill up it to the upper level.
Install the RH/LH side cowl and center cowl.

WATER PUMP

MECHANICAL SEAL (WATER SEAL)
INSPECTION
At the checking hole, inspect the mechanical seal
for damage and leakage.
If the coolant leaks, disassemble the water pump,
check the mechanical seal and replace it.
WATER PUMP / IMPELLER REMOVAL
Remove the coolant inlet hose.
COOLING SYSTEM
6-7