DAELIM VJF125 Service Manual page 144

SPARK PLUG SPARK PLUG SPARK PLUG
SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG
SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG
SPARK PLUG SPARK PLUG SPARK PLUG SPARK PLUG
SPARK PLUG SPARK PLUG SPARK PLUG
CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER
CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER
CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER
CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER CYLINDER HEAD COVER
CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER
CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER
CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER
CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER CAM SHAFT HOLDER
CAMSHAFT
REMOVAL
TENSIONER
TENSIONER TENSIONER TENSIONER TENSIONER TENSIONER TENSIONER
TENSIONER TENSIONER TENSIONER TENSIONER TENSIONER TENSIONER
TENSIONER TENSIONER TENSIONER TENSIONER TENSIONER TENSIONER
TENSIONER TENSIONER TENSIONER
CYLINDER HEAD / VALVES
Remove the side cowl.
Remove the noise suppressor cap assembly from
the spark plug.
Loosen the screw of the cam chain tensioner and
remove the tensioner mounting bolt.
Remove the AC generator cap and crank shaft hole
cap out of the left crankcase cover.
Turn the crankshaft to the left, and align the T mark
of the flywheel with the index mark of the LH.
crankcase cover.
Verify that the piston is located at the top dead center.
(Make all camshaft lobes face downward.)
If all camshaft lobes face upward, rotate the crankshaft
to the left for 1 turn (180 ), and align the T mark
with the index mark once again.
Remove the fuel tank.
Loosen the 4 cylinder head cover special bolts and
remove the cover.
Remove the 8 flange bolts of the camshaft holder
and remove the camshaft holder from the
cylinderhead.
Remove the cam chain from the camshaft.
10-3