Reauthenticate Port(S) For Mac Based 802.1X - Allied Telesis AT-9724TS Installation And User Manual

This window displays the following information:
Parameter
Unit
Port
Auth State
BackendState
OpenDir
PortStatus
Note: The user must first globally enable 802.1X in the Advanced Settings window in the Configuration folder before reauthenticating
ports. Information in the Reauthenticate Ports Table cannot be viewed before enabling 802.1X.

Reauthenticate Port(s) for MAC Based 802.1x

To reauthenticate ports for the MAC side of 802.1x, the user must first enable 802.1x by MAC address in the Advanced Settings window. Click Port
Access Entity > PAE System Control > Reauthenticate Port(s) to open the following window:
To reauthenticate ports, first choose the switch in the switch stack by using the Unit pull-down menu, then the range of ports in the From and To field.Then
the user must specify the MAC address to be reauthenticated by entering it into the MAC Address field and checking the corresponding check box.To begin
the reauthentication, click Apply.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Description
Choose the Switch ID number of the Switch in the switch stack to be modified.
The port number of the reauthenticated port.
The Authenticator State will display one of the following: Initialize, Disconnected, Connecting, Authenticating,
Authenticated, Aborting, Held, ForceAuth, ForceUnauth, and N/A.
The Backend State will display one of the following: Request, Response, Success, Fail, Timeout, Idle, Initialize, and N/A.
Operational Controlled Directions are both and in.
The status of the controlled port can be Authorized, Unauthorized, or N/A.
Figure 6- 82. Reauthenticate Ports – MAC based 802.1x
91