Transmitted (Tx) - Allied Telesis AT-9724TS Installation And User Manual

The following fields can be set:
Parameter
Time Interval
Record Number
Crc Error
Under Size
Over Size
Fragment
Jabber
Drop
Show/Hide
Clear
View Table
View Line

Transmitted (TX)

Click the Transmitted (TX) link in the Error folder of the Monitoring menu to view the following graph of error packets received on the Switch.To select a port
to view these statistics for, first select the Switch in the switch stack by using the Unit pull-down menu and then select the port by using the Port pull down
menu.The user may also use the real-time graphic of the Switch and/or switch stack at the top of the web page by simply clicking on a port.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Figure 9- 10. Rx Error Analysis window (table)
Description
Select the desired setting between 1s and 60s, where "s" stands for seconds.The default value is one second.
Select number of times the Switch will be polled between 20 and 200.The default value is 200.
Counts otherwise valid packets that did not end on a byte (octet) boundary.
The number of packets detected that are less than the minimum permitted packets size of 64 bytes and have a
good CRC. Undersize packets usually indicate collision fragments, a normal network occurrence.
Counts packets received that were longer than 1518 octets, or if a VLAN frame is 1522 octets, and less than
the MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to 1522.
The number of packets less than 64 bytes with either bad framing or an invalid CRC.These are normally the
result of collisions.
The number of packets with lengths more than the MAX_PKT_LEN bytes. Internally, MAX_PKT_LEN is equal
to 1522.
The number of packets that are dropped by this port since the last Switch reboot.
Check whether or not to display Crc Error, Under Size, Over Size, Fragment, Jabber, and Drop errors.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Chart Clicking this button instructs the Switch to display a line graph rather than a table.
163