Umb Cast (Rx) - Allied Telesis AT-9724TS Installation And User Manual

Parameter
Time Interval
Record Number
Bytes
Packets
Unicast
Multicast
Broadcast
Show/Hide
Clear
View Table
View Line

UMB Cast (RX)

Click the UMB Cast (RX) link in the Packets folder of the Monitoring menu to view the following graph of UMB cast packets received on the Switch.To
select a port to view these statistics for, first select the Switch in the switch stack by using the Unit pull-down menu and then select the port by using the Port
pull down menu.The user may also use the real-time graphic of the Switch and/or switch stack at the top of the web page by simply clicking on a port.
To view the UMB Cast Table, click the View Table link, which will show the following table:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Description
Select the desired setting between 1s and 60s, where "s" stands for seconds.The default value is one second.
Select number of times the Switch will be polled between 20 and 200.The default value is 200.
Counts the number of bytes received on the port.
Counts the number of packets received on the port.
Counts the total number of good packets that were received by a unicast address.
Counts the total number of good packets that were received by a multicast address.
Counts the total number of good packets that were received by a broadcast address.
Check whether to display Bytes and Packets.
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph.
Chart Clicking this button instructs the Switch to display a line graph rather than a table.
Figure 9- 5. Rx Packets Analysis window (line graph for Unicast, Multicast, and Broadcast Packets)
159