Upload Configuration; Upload Log; Multiple Image Services; Firmware Information - Allied Telesis AT-9724TS Installation And User Manual

Enter the IP address of the TFTP server and specify the location of the switch configuration file on the TFTP server.
Click Start to initiate the file transfer.

Upload Configuration

To upload the Switch's settings to a TFTP server, click on the TFTP Service folder in the Maintenance folder and then click the Save Settings link:
Figure 10- 3. Upload Configuration window
Enter the IP address of the TFTP server and the path and filename for the configuration file on the TFTP server.
Click Start to initiate the file transfer.

Upload Log

To upload the Switch history log file to a TFTP server, open the TFTP Service folder in the Maintenance folder and then click the Upload Log link:
Figure 10- 4. Upload Log window
Enter the IP address of the TFTP server and the path and filename for the history log on the TFTP server.
Click Start to record the IP address of the TFTP server and to initiate the file transfer.

10-2 Multiple Image Services

The Multiple Image Services folder allow users of the AT-9724TS to configure and view information regarding firmware located on the Switch.The Switch
allows two firmware images to be stored in its memory and either can be configured to be the boot up firmware for the Switch. For information regarding
firmware images located on the Switch, open the Firmware Information link.The default setting for the Switch's firmware will have the boot up firmware
stored in Image 1, but the user may set either firmware stored to be the boot up firmware by using the Config Firmware Image window.

Firmware Information

The following screen allows the user to view information about current firmware images stored on the Switch.To access the following screen, click
Maintenance > MULTIPLE IMAGE Services > Firmware Information.
185
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch