Snmp User Table - Allied Telesis AT-9724TS Installation And User Manual

To display the detailed entry for a given user, click on the hyperlinked User Name.This will open the SNMP User Table Display page, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
To return to the SNMP User Table, click the Show All SNMP User Table Entries link.
To add a new entry to the SNMP User Table Configuration, click on the Add button on the SNMP User Table page.
This will open the SNMP User Table Configuration page, as shown below.
The following parameters can be set:
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Figure 8- 2. SNMP User Table Display window
Description
An alphanumeric string of up to 32 characters.This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
V1 – Indicates that SNMP version 1 is in use.
V2 – Indicates that SNMP version 2 is in use.
V3 – Indicates that SNMP version 3 is in use.
None – Indicates that no authorization protocol is in use.
MD5 – Indicates that the HMAC-MD5-96 authentication level will be used.
SHA – Indicates that the HMAC-SHA authentication protocol will be used.
None – Indicates that no authorization protocol is in use.
DES – Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56) standard.
Figure 8- 3. SNMP User Table Configuration window
150