Vrrp Interface Settings - Allied Telesis AT-9724TS Installation And User Manual

VRRP Interface Settings

The following window will allow the user to view the parameters for the VRRP function on the Switch.To view this window, click Configuration > Layer 3
IP Networking > VRRP > VRRP Configuration:
The following fields are displayed in the window above:
Parameter
Interface Name
Authentication type
VRID
Display
Delete
Click the Add button to display the following window to configure a VRRP interface.
Or, the user may click the hyperlinked Interface Name to view the same window:
The following parameters may be set to configure an existing or new VRRP interface.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Figure 6- 127.VRRP Configuration window
Description
An IP interface name that has been enabled for VRRP.This entry must have been previously set in the IP
Interfaces table.
Displays the type of authentication used to compare VRRP packets received by a virtual router. Possible
authentication types include
No authentication – No authentication has been selected to compare VRRP packets received by a virtual router.
Simple Text Password – A Simple password has been selected to compare VRRP packets received by a virtual
router, for authentication.
IP Authentication Header – An MD5 message digest algorithm has been selected to compare VRRP packets
received by a virtual router, for authentication.
Displays the virtual router ID set by the user.This will uniquely identify the VRRP Interface on the network.
Click the View button to display the settings for this particular VRRP entry.

Click the to delete this VRRP entry.
Figure 6- 128.VRRP Interface Settings – Add window
126