Force Ibmc Update (J1B5); Table 17: Server Board Jumpers (J1B5, J1C2, J1C3, J1B4, J6A3, J6A2); Table 18. Force Ibmc Update Jumper - Intel S5500WB12V Specification

Intel® Server Board S5500WB TPS

Table 17: Server Board Jumpers (J1B5, J1C2, J1C3, J1B4, J6A3, J6A2)

Jumper Name
J1B5: BMC Force
Update jumper
J1C2: Password Clear
J1C3: BIOS Recovery
Mode
J1B4: CMOS Clear
J6A3: Video Master
J7A2: ME Firmware
Force Update
J6A2: Serial Interface
6.1.1

Force IBMC Update (J1B5)

When performing a standard BMC firmware update procedure, the update utility places the
BMC into an update mode, allowing the firmware to load safely onto the flash device. In the
unlikely event the BMC firmware update process fails due to the BMC not being in the proper
update state, the server board provides a BMC Force Update jumper (J1B5) which will force the
BMC into the proper update state. The following procedure should be followed in the event the
standard BMC firmware update process fails.
Jumper Position
1-2
2-3
1. Power down and remove the AC power cord.
2. Open the server chassis. See your server chassis documentation for instructions.
3. Move jumper from the default operating position, covering pins1 and 2, to the enabled
position, covering pins 2 and 3.
4. Close the server chassis.
5. Reconnect the AC cord and power up the server.
Revision 1.9
Mode of
Jumper Position
Operation
1-2 Normal
2-3 Update
1-2 Normal
2-3 Clear Password
1-2 Normal
2-3 Recovery
1-2 Normal
2-3 Clear CMOS
Settings
1-2 Internal
2-3 External
1-2 Disabled
2-3 Enabled
1 – 2
DCD to DTR
3 – 4
DSR to DTR

Table 18. Force IBMC Update Jumper

Mode of
Operation
Normal IBMC GPIO[1] is pulled HIGH. Default position.
Update IBMC GPIO[1] is pulled LOW.
Intel order number E53971-008
Note
IBMC GPIO[1] is pulled HIGH. Default position.
IBMC GPIO[1] is pulled LOW.
ICH10R INTRUDER# pin is pulled HIGH. Default
position.
ICH10R INTRUDER# pin is pulled LOW.
ICH10R GPIO [55] is pulled HIGH. Default
position.
ICH10R GPIO [55] is pulled LOW.
ICH10R RTCRST# pin is pulled HIGH. Default
position.
ICH10R RTCRST# pin is pulled LOW.
Internal connector will override if both connectors
are used.
External connector will override if both
connectors are used.
Default
Data Carrier Detect
Data Set Ready
Note
Configuration Jumpers
47