3.13 I/O Slots; X16 Riser Slot Definition; Pe Width Strapping; Slot 1 Pci Express* X8 Connector - Intel S5500WB12V Specification

Product specification
Table of Contents

Advertisement

Functional Architecture
®
The Intel
Server Board S5500WB provides a mechanism to support video to the front panel
via the use of an internal header. When a monitor is plugged into the front panel video
connector, the rear panel video stream is disconnected.
There is a jumper option to change this default action. When the internal header is used by a
third-party Management card to do KVM over LAN and then when a monitor is plugged into the
rear panel video connector, the video stream to the internal header is cut off.

3.13 I/O Slots

3.13.1

X16 Riser Slot Definition

Slot 6 was defined to support riser cards. Slot 6 has a x16 physical connector with a PCI
Express* Gen II x8 electrical interface. Two clocks are provided so the bus can be bifurcated
into two x4 connectors.
Because of CPU placement, a 1U system supports only PCI Express* adapters that meet the
PCI SIG half card definition. Full-length boards are supported in a 2U system by using a taller
riser and extending the board over the 1U CPU heatsinks or if CPU2 is unpopulated.
Appendix A describes the pin assignments for this connector.
3.13.2

PE WIDTH Strapping

®
On the Intel
Server Board S5500WB, the IOH needs to be informed of the PCI Express* bus
width during power on. This is accomplished using the PEWIDTH input straps. The mechanism
used is the PEWIDTH bits, one bit is used to signify the width and number of PCI Express*
buses used by the riser. For slot 6, the PEWIDTH bit used is 0.
1U one x8
2U two x4
By using this mechanism for selecting PCI Express* port width, you can avoid a BIOS
rediscover and reboot.
The PEWIDTH is pulled up to 3.3 V Aux on the baseboard and grounded, if necessary, by the
riser. The baseboard provides an inverter and voltage level translator before passing this signal
to the IOH.
3.13.3

Slot 1 PCI Express* x8 Connector

Slot 1 provides a PCI Express* x4 bus on an x8 connector, if provided, for use in a 2U chassis
that uses LP boards without risers. Although it is feasible to use the IOM at the same time, it
would require 2U chassis back panel changes.
36

Table 11. PEWIDTH Strapping Bits

Riser
1 x8 PCI Express* Slot
2 X4 PCI Express* Slots
Intel order number E53971-008
Description
0
1
Intel® Server Board S5500WB TPS
PEWIDTH0
pin A50
Revision 1.9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S5500wbrS5500wb

Table of Contents