Table of Contents
Advertisement
Jumper Blocks
Note: BIOS Error Manager should report a 5224 and 5221 error codes (Password clear
jumper is set and Passwords cleared by jumper).
6. Power down the server and unplug the power cords.
7. Open the chassis, remove the Riser #2 assembly, and move the jumper back to the
default position (covering pins 1 and 2).
8. Reinstall the Riser #2 assembly.
9. Close the server chassis and reattach the power cords.
10. Power up the server.
10.4 Management Engine (ME) Firmware Force Update Jumper Block
When the ME Firmware Force Update jumper is moved from its default position, the ME is
forced to operate in a reduced minimal operating capacity. This jumper should only be used if
the ME firmware has gotten corrupted and requires re-installation. The following procedure
should be followed.
Note: System Update and Recovery files are included in the System Update Packages (SUP)
posted to Intel's website.
1. Turn off the system and remove power cords.
2. Remove Riser Card Assembly #2.
3. Move the ME FRC UPD Jumper from the default (pins 1 and 2) operating position to the
Force Update position (pins 2 and 3).
4. Re-attach system power cords.
5. Power on the system.
Note: System Fans will boost and the BIOS Error Manager should report an 83A0 error
code (ME in recovery mode).
6. Boot to the EFI shell and update the ME firmware using the "MEComplete####.cap" file
(where #### = ME revision number) using the following command: iflash32 /u /ni
MEComplete####.cap.
7. When update has successfully completed, power off system.
8. Remove AC power cords.
9. Move ME FRC UPD jumper back to the default position.
Note: If the ME FRC UPD jumper is moved with AC power applied, the ME will not
operate properly. The system will need have the AC power cords removed, wait for at
least 10 seconds and then reinstalled to ensure proper operation.
204
Intel® Server Board S1200V3RP TPS
Revision 1.2
Hide quick links:
Advertisement
Table of Contents
