Digi WAN 3G User Manual page 183

Using the Reset button
If the Digi device cannot be accessed from the web interface, the configuration can be restored to
factory defaults by using the Reset button.
Power off the Digi device.
1
Locate the Reset button or pin on your device.
2
Hold the Reset button down gently with a non-conductive, small diameter tool (such as
3
wood or plastic) with a blunt end (NOT SHARP or the button could be damaged). Power on
the device while holding the Reset button down.
After a few seconds you may see a 1-1-1 blink once on some devices.
4
Wait until you see the Status LED blink a 1-5-1 pattern, then release the reset button.
5
Wait for the device to boot up. At this time, the configuration is returned to factory defaults.
6
7 Now, if desired, power off the device, though this is not necessary. Powering off the device
before releasing the button guarantees the configuration will NOT be reverted. Powering off
the device just after releasing the button will result in an unknown configuration, possibly
having some or all settings reverted to defaults.
D i g i d e v i c e a d m i n i s t r a t i o n
1 8 3