Digi WAN 3G User Manual page 118

Close connection after the following number of idle seconds: Enable to close an idle

connection. Use the Timeout field to enter the number of seconds that the connection
will be idle before it is closed. This can be 1 to 65000 seconds.
Close connection when DCD goes low: When selected, the connection will be closed

when the DCD (Data Carrier Detected) signal goes low.
Close connection when DSR goes low: When selected, the connection will be closed

when the DSR (Data Set Ready) signal goes low.
UDP settings
The UDP Settings are displayed only when the current serial port is configured with the UDP
Sockets or the Custom Profile.
Send Socket ID: Include an optional identifier string with the data sent over the

network. The Socket ID can be 1 to 256 ASCII characters. To enter non-printable
characters, use these key sequences:
Display current serial port settings
To display the current serial port settings for a Digi device, enter the display techsupport
command from the command line interface.
Key
Character
Sequence
backspace \b
formfeed \f
tab \t
new line \n
return \r
backslash \\
hexadecimal
\xhh
values
C o n f i g u r e D i g i d e v i c e s
1 1 8