Here are some examples of commands used to configure Digi devices. See the Introduction of the
Digi Connect Family Command Reference for a complete list of features and tasks that can be
configured and performed from the command line.
To configure:
access control (IP filtering): limit network access
to device
alarms
autoconnection behaviors for serial port
connections
Ethernet communications parameters
IP forwarding
host name
Industrial Automation/Modbus
mobile statistics
modem emulation
network options
network services
Point-to-Point (PPP) outbound connections
port buffering
port profile for a serial port
provisioning CDMA cellular modules
remote management settings
system-identifying information
serial port options--general
serial TCP and serial UDP
RealPort configuration options
C o n f i g u r e D i g i d e v i c e s
Use this command:
set accesscontrol
set alarms
set autoconnect
set ethernet
set forward
set host
set ia
display mobile
set pmodem
set network
set service
set pppoutbound
set buffer
set profiles
display provisioning
provision
set mgmtconnection
set mgmtglobal
set mgmtnetwork
set system
set serial
set tcpserial and set udpserial
set realport
1 4 8