Digi WAN 3G User Manual page 145

Digi - connect wan 3g wireless router
Hide thumbs Also See for WAN 3G:
Table of Contents

Advertisement

RealPort configuration
RealPort software must be installed and configured on each PC that uses the RealPort ports on the
Digi device. This RealPort software is available for downloading from the Digi Support site.
Install RealPort software
From the Digi Support site:
From a browser, go to www.digi.com.
1
Click the Support link and select
2
Select Your Product for Support,
Under
3
and click Submit.
Active Products, select your
Under
4
OS Specific Diagnostics, Utilities and MIBs, s
Under
5
your computer from the list.
Realport for Windows, click the zip file.
6
Under
7
Unzip the zip file.
Run the RealPort setup wizard.
8
RealPort configuration settings
Applications > Realport displays a page for configuring the RealPort application. Settings on this
page include:
RealPort Settings
Enable Keep-Alives: Enables the sending of RealPort keep-alives. These keep-alives
are messages inside the RealPort protocol, sent approximately every 10 seconds, to tell
whoever is connected that the connection is still alive. RealPort keep-alives are different
from TCP keep-alives, which are done at the TCP layer.
Note that RealPort keep-alives generate additional traffic which may be undesirable
in situations where traffic is measured for billing purposes.
Enable Exclusive Mode: Exclusive mode will only allow a single connection from any
one RealPort client ID to be connected. If a subsequent connection occurs and it has the
same source IP as an existing connection, the old existing connection will be forcibly
reset on the assumption that it is stale, if this parameter is set.
Device Initiated RealPort Settings:
Index: An empty list means that no Device Initiated RealPort Connections have been
configured
Host or IP Address: The IP address or DNS name of the client to connect to.
Port: The network port to connect to on the client. The default port for VNC servers is
8771.
Retry Time: The amount of time in seconds to wait before reattempting a failed
connection to the client.
Drivers.
select your Digi device from the product list
Digi device from the product list.
C o n f i g u r e D i g i d e v i c e s
elect the operating system for
1 4 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents