Digi WAN 3G User Manual page 117

Digi - connect wan 3g wireless router
Hide thumbs Also See for WAN 3G:
Table of Contents

Advertisement

TCP settings
The TCP Settings are displayed only when the current serial port is configured with the TCP
Sockets or the Custom Profile. The settings are as follows:
Send Socket ID: Include an optional identifier string with the data sent over the
network. The Socket ID can be 1 to 256 ASCII characters. To enter non-printable
characters, use these key sequences:
Send data only under any of the following conditions: Enable if it is required to set
conditions on whether the Digi device sends the data read from the serial port to the
TCP destination. Conditions include:
Send when data is present on the serial line: Send the data to the network destinations
when a specific string of characters is detected in the serial data. Enter the string 1 to 4
characters in the Match String field. To enter non-printable characters, use these key
sequences:
Strip match string before sending: Match string before sending to strip the string from
the data before it is sent to the destination.
Send after the following number of idle: Send the data after the specified number of
milliseconds has passed with no additional data received on the serial port. This can be 1
to 65,535 milliseconds.
Send after the following number of bytes: Send the data after the specified number of
bytes has been received on the serial port. This can be 1 to 65,535 bytes.
Key
Character
Sequence
backspace
\b
formfeed
\f
tab
\t
new line
\n
return
\r
backslash
\\
hexadecimal
\xhh
values
Key
Character
Sequence
hexadecimal
\xhh
values
tab
line feed
\n
backslash
C o n f i g u r e D i g i d e v i c e s
\t
\\
1 1 7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents