Digi WAN 3G User Manual page 130

SNMP Configuration settings:
 Enable Simple Network Management Protocol (SNMP): This checkbox enables or
disables use of SNMP.
– The Public community and Private community fields specify passwords required to
get or set SNMP-managed objects. Changing public and private community names from
their defaults is recommended to prevent unauthorized access to the device.
Public community: The password required to get SNMP-managed objects. The
default is public.
Private community: The password required to set SNMP-managed objects. The
default is private.
– Allow SNMP clients to set device settings through SNMP: This checkbox enables or
disables the capability for users to issue SNMP "set" commands uses use of SNMP
read-only for the Digi device.
Enable Simple Network Management Protocol (SNMP) traps: Enables or disables

the generation of SNMP traps.
– Trap Destinations:
– Primary/Secondary: The IP address of the system to which the SNMP agent should
send traps. To enable any of the traps, a non-zero value must be specified. The primary
destination is required. The secondary destination is optional. For Digi devices that
support alarms, this field is required in order for alarms to be sent in the form of SNMP
traps. See "Alarms" on page 121.
At the bottom of the page are checkboxes for the SNMP traps that can be used:
– Generate authentication failure traps: The SNMP agent will send SNMP
authentication traps when there are authentication failures.
– Generate login traps: The SNMP agent will send SNMP login traps on login attempts.
– Generate cold start traps: The SNMP agent will send traps on cold starts of the Digi
device server.
– Generate link up traps: The SNMP agent will send link up traps when network
connections are established.
C o n f i g u r e D i g i d e v i c e s
1 3 0