User Line 2 Link Messages - Lexmark T632 Service Manual

4060-xxx
User attendance messages (continued)
Primary message
280 Paper Jam
Check Finisher
281 Paper Jam
Check Finisher
282 Staple Jam
Check Stapler
283 Staple Jam
Check Stapler
1565 Emul Error
Load Emul Option

User line 2 link messages

If the printer is locked on a particular link, the link indication displays. If the printer is ready to process
any link, no messages display. Link messages are listed in the following table.
User message
Parallel
Serial
Serial x
Network x
LocalTalk x
Infrared
Infrared x
2-32
Service Manual
Secondary message
Leave Job in Finisher
Remove Job from
Finisher
Remove Job from
Finisher
Explanation
Standard Parallel Port, if available.
Standard Serial Port, if available.
Serial Port is attached to PCI connector x, where x=1, 2, or 3.
Network card x is attached to PCI connector x, where x=1, 2, or 3.
LocalTalk Card x is attached to PCI connector x, where x=1, 2, or 3.
Standard Infrared port, if available.
Infrared Port x is attached to PCI connector x, x=1, 2, or 3.
Explanation
Primary: Paper is jammed in the finisher option. Open
the finisher option side door or top cover to access the
jammed pages.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
Primary: Paper is jammed in the finisher option. Open
the finisher option side door or top cover to access the
jammed pages.
Secondary: When this message is displayed, remove
the job from the finisher. The printed will not reprint the
removed sheets.
Primary: A staple jam has been detected during
normal stapler operation.
Secondary: The printer flashes the secondary
message to indicate that all accumulated sheets
should be removed during the jam clearance.
A staple jam has been detected during the priming
operation.
Note: Press Go to initiate priming and resume printing
while either of the primary or secondary messages
displays.
This message appears when the IPDS emulation
version contained in the SIMM does not function with
the printer code. This message automatically clears in
30 seconds, and the IPDS emulation is disabled. No
other printer functions are affected. The correct IPDS
emulation must be downloaded.